Remember when we published a story on Harbor Freight's jack stands being recalled because their locking pawls weren't fully engaging? It turns out that the replacement jack stands may have issues too — big ones.
According to a report published Friday by The Drive, the problem involves a customer who attempted to support his Volkswagen Golf with a set of new three-ton Harbor Freight jack stands, only to have one of them split down the middle. Yes, you read that correctly.
For more Cars
Subscribe to the Cars newsletter, receive notifications and see related stories on CNET.
The splitting welds are likely the result of improper welding done at the factory, where the weld doesn't achieve full penetration and therefore doesn't fully secure the two pieces of metal. Needless to say, this is not something you should see on a three-ton jack stand with a Golf sitting on it.
Harbor Freight didn't immediately respond to Roadshow's request for comment.
The post-failure photos of the jack stand are pretty gnarly and would serve as plenty of evidence that maybe we automotive enthusiasts should start purchasing our safety-critical garage equipment elsewhere.
Also, if you haven't checked your jack stands (PDF) to see if they're a part of the Harbor Freight recall, do so at that link, and check over your replacements carefully before trusting your life to them.
7 tire shine products compared
See all photos
Now playing: Watch this: Upgrade your garage with LiftMaster's new myQ suite 2:21 Comments Recalls Car Culture Notification on Notification off Cars